Volvo RWD Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

'92 240 Stalls At Startup After Putting Into DRIVE or REVERSE

posted by  bob adams on  Sun May 17 07:17 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 26 12:24 CST 2012
[RELATED]

I have a 92 240 station wagon with automatic transmission. It will start but have to put my foot of the brake and rev the engine to keep it running. It will sometimes run for a short period of time like it is hitting on three cylinders and then stall. If I put in DRIVE or REVERSE it will immediately stall. I replaced the RPM (Crank?) sensor. Any advice would be most welcome.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '92 240 Stalls At Startup After Putting Into DRIVE or REVERSE
posted by  bob adams  on Sun May 17 07:17 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.