Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M47 service - Seals & Gasket replacement 200 1991

posted by  vvpete on  Wed Jun 10 08:01 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 10 14:10 CST 2014
[RELATED]

I am replacing the seals & gaskets on an M47 5 speed, and ran into trouble getting the rear 5th gear housing off with the Bently procedure. The seal that leaks is the rear housing to gearbox seal, and have the VOlvo seal kit with all the transmission seals.
So far, trans is on the bench withbellhousing, top and rear cover removed, countershaft bolt, shim & thrust washer removed, but cannot pull the case off while pressing against the countershaft inner bearing race, per Bently manual procedure.
Anybody do this procedure, and have first hand experience?
Thanks,
Pete






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M47 service - Seals & Gasket replacement [200][1991]
posted by  vvpete  on Wed Jun 10 08:01 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.