Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

blower motor question: grinding off the spacers (and gawd what a vile project this is!!) 200

posted by  montysano on  Fri Jun 12 07:56 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 29 16:46 CST 2014
[RELATED]

Hi all,

I'm replacing the blower motor in my son's '83 240. I've got the old motor out, and am ready to remove the spacers. I'm going to pick a cutoff tool for my Dremel, cut the spacers off, then smooth it flat.

One thing scares me: is there enough thread left after removing the spacers to hold the motor firmly? Or should I plan on having to use a nut on the backside?

monty






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New blower motor question: grinding off the spacers (and gawd what a vile project this is!!) [200]
posted by  montysano  on Fri Jun 12 07:56 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.