Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2019 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

removing head stalled by 2" of plastic. 900 1993

posted by  soundmiami on  Sun Jun 14 07:33 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 18:58 CST 2014
[RELATED]

This project has gone by the book thanks to the FAQ lots of blaster and Bruce Young's "rope trick" (thanks)

However as I get ready to pull the head it appears the timing cover backing plate is going to be in the way. There is nothing in the FAQ about it. Do you remove the cam pulley and tensioner first? Can I hit the cam pulley bolt with my impact? I started to back out the little stud on the tensioner with an 8mm open end wrench but I though I'd ask before I end up with a 8mm stud embedded in some part of my body.

http://www.flickr.com/photos/33680473@N08/3625260527/

Charles
I can build a computer but can't get an image to post!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New removing head stalled by 2&quot; of plastic. [900][1993]
posted by  soundmiami subscriber  on Sun Jun 14 07:33 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.