Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

SPARK PLUG GLUE 200 1990

posted by  jdl on  Fri Jun 19 10:46 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Feb 6 11:55 CST 2012
[RELATED]

Hi. I recently tried to rehab a stripped spark plug hole with a K-D inside out thread tool. The plug now goes all the way in, but the thread tap must have taken out too much material and now fully seated the plug spins with more than 1 or 2 lbs. torque.
I want to do something before the plugs pops out during driving. I read a post here about using a glue in just this kind of situation. It must have been a thread locker, but I don't remember.
Can anyone point me to that post, or suggest something based on your own experience. Thanks, jdl.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New SPARK PLUG GLUE [200][1990]
posted by  jdl  on Fri Jun 19 10:46 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.