Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bushing (TAB) dimensions? 200 1991

uid 46284's pic
posted by  Boerre on  Sun Jul 19 07:28 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jun 24 12:56 CST 2010
[RELATED]

Dear Bricksters,

I am gearing up for a TAB job, doing research and collecting tools. I want to use poly bushings from FCP and use a hole saw to remove the rubber innards from the old one. Problem: what size hole saw do I need? What is the diameter of the rubber part of the bushing (and I mean the rear trailing arm - rear bushing)? And how deep is the rubber part, i.e. how long would the saw need to be? Does anyone happen to know?

Otherwise I'll have to wait for the bushing to arrive before I order the saw.
Many thanks in advance!
Boerre






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bushing (TAB) dimensions? [200][1991]
posted by  Boerre  on Sun Jul 19 07:28 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.