Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Zero compression on cylinder 1 200 1993

posted by  USMA on  Fri Aug 7 03:27 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Sep 3 13:50 CST 2014
[RELATED]

Without notice we started one of the '93 240 with 130k miles and the engine was running very rough. I notice a metal tapping sound not too loud. I pulled all the plugs and they looked good. Ran a compression test and number 1 cylinder had 0 while the others were all around 145 psi. Looking through the oil fill cap the springs are all moving and I did not notice anything abnormal.

Just wanted to get some advise on my test plan.

(1) remove the valve cover and inspect the springs to make sure they are closing
(2) Check the timing belt and verify timing
(3) Remove head insect for valve or piston damage

Assuming the worse are there facility that sell short blocks?

Thanks

Roger






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Zero compression on cylinder 1 [200][1993]
posted by  USMA  on Fri Aug 7 03:27 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.