Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tailights revisited 200 1993

posted by  leugim on  Thu Sep 3 09:19 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 20:49 CST 2014
[RELATED]

I recently replaced my rear light assemblies due to cracked lenses and water infiltration.

All seemed fine four about 4 months. Then, I started to get the dreaded bulb failure warning light.

Upon investigating I notice that the passenger position light was not working. Initially hoping it was a bad bulb, I switched it out and found it was not the bulb. I searched some more and found that the passenger brake light has a melted spot on the printed circuit.

Whatever could cause this?

I am planning on getting a new printed circuit and start again. Other thoughts are apprciated as usual.

I don't get to the internet everyday so if I don't respond right away don't be offended.

Thanks
--
Happy Motoring! 93' 244 and 2002 S60'''''%%%% '






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tailights revisited [200][1993]
posted by  leugim subscriber  on Thu Sep 3 09:19 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.