Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Timing alignment (b230) 200 1985

posted by  Shaughnessy on  Mon Sep 14 04:37 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 3 23:53 CST 2014
[RELATED]

Where is the correct location for the timing marks on the crank pully, when seen with a timing gun?

At idle my engine runs good. I did put the sprockets each at their correct placement (to the best of my ability). When I tested the timing with the timing light, the marks are to the drivers side of the markings on the shroud. If I had to venture a guess, the 1st (left) mark is to the right of the farthest notch on the shroud. I have not checked it today, and I was tired when I checked it, so my memory might be a bit off.

*I just re-checked it. The left mark is right under the "20" mark on the shroud). From what I got in an email, I'm thinking I'm off by 1 marking. Meaning, I think I need to adjust the timing a bit

Is there a diagram showing the proper placement of the markings online (here or other) or in the Bentley?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Timing alignment (b230) [200][1985]
posted by  Shaughnessy  on Mon Sep 14 04:37 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.