Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

flywheel (manual) install with crank position sensor 200 1989

posted by  greg_mustang on  Sun Oct 4 13:06 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

Hi All,

Wow i have not written here in a couple years I think.

Anyhow volvos are working great, as expected. I am in the process of converting my 89 240 from auto to manual (surprisingly simple job actually). The doner car is the same year model.
I just have one question:

Before replacing the flywheel, I looked for some marking, figuring that the crank sensor needs to know TDC position; All I see is a section of the flywheel without "holes" or knotches for the sensor. I assume this is a 'marking'. I looked at the replacement flywheel I have for the clutch, and it too has a section without any "holes".

Q: As long as I put that 'hole-less' section in the same position as it was before, I should be ok for crank position sensing, correct?
Is there anything else to watch out for?

I hope my explanation is clear.

Thanks as always,
Greg Mustang
Montreal - Canada
--
Greg Mustang - www.volvoclassic.bravehost.com






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New flywheel (manual) install with crank position sensor [200][1989]
posted by  greg_mustang  on Sun Oct 4 13:06 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.