Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Leak at water pump metal tube 200 1991

posted by  jimo14 on  Mon Oct 26 04:17 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 6 18:50 CST 2014
[RELATED]

I just replaced the water pump on a friends '91 while doing a timing belt replacement. It turns out that the rubber sleeve which seals the metal tube at the back of the pump leaks significantly.

I've heard that it's possible to remove the nut at the rear of the tube behind the engine in order to slide it backwards far enough to install a replacement sleeve. Has anyone done this and is it easier to gain access from above or below? It seems like a very tight squeeze back there. Thanks for any tips.

Jim






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Leak at water pump metal tube [200][1991]
posted by  jimo14  on Mon Oct 26 04:17 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.