Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Holding the intermediate shaft gear stationary 700 1991

posted by  Andrew in AL on  Sat Oct 31 18:48 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

Did not find this in the FAQs.

I have removed the bolt holding this gear at at a yard, putting a screwdriver through one of the holes and wedging it while braking it loose ...but I am not sure if this is the best way.

I am to replace the intermediate shaft seal on my sis 740. Is this the best way to hold it steady and to re-tighten?

Also is there a better way than a wedged screwdriver to take care of the cam gear?

Thanks
--
' Of all bad men religious bad men are the worst. '' (C S Lewis ; on Evil Men) 89 764 (170K), '94 940T (265K), 92 245 (150K)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Holding the intermediate shaft gear stationary [700][1991]
posted by  Andrew in AL subscriber  on Sat Oct 31 18:48 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.