Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Ball joint fit to control arm, interference? 700 1991

posted by  ibs740 on  Tue Dec 1 02:43 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:01 CST 2014
[RELATED]


Had a clink on some road bumps & during low speed turning. Classic ball joint gone bad. I replaced the joint. When I removed it I noticed that the inside of the control arm was corroded & definately not an interference fit to the ball joint. I could tell there was no side to side movement because of the distinct circular impressions on the joint body. There would be lines, metal transfer etc. if the joint moved.

My question is should this be an interference fit?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ball joint fit to control arm, interference? [700][1991]
posted by  ibs740  on Tue Dec 1 02:43 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.