Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

New Caliper Bolts Are Longer Than Old Ones 200 1990

posted by  jdbs3 on  Wed Dec 9 01:23 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 14 15:19 CST 2014
[RELATED]

My front end parts arrived yesterday from FCP Groton (dust shields, calipers, brakes, rotors, etc.).

As others have found, the ball joints I received are not TRW, rather Moog. Just out of curiosity, why is the right ball joint to strut anchor nut a lock type nut, while the left side has a single unit nut/washer?

The more important question is on the caliper mounting bolts. The new bolts are 3/16" longer. The new bolts are also threaded right to the bolt head, while the old ones were only threaded half way. Yet it is the correct part number (FCP got them from Volvo) #975546.

I'm concerned that these longer bolts may either thread in too close to the back of the hub or rotor, or thread in only so far and stick out a bit on the caliper.

Are these longer bolts going to cause a problem; are they okay to use? And if not, what should I be ordering?

thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New New Caliper Bolts Are Longer Than Old Ones [200][1990]
posted by  jdbs3  on Wed Dec 9 01:23 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.