Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How to reinstall hub assembly 200 1990

posted by  mshonline on  Mon Feb 1 09:42 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 27 06:54 CST 2010
[RELATED]

Hey all,

Just repacked the front bearings on a 1990 240. It was in the routine maintenance section of the Haynes manual, so i thought it would be routine. No such luck

I'm at the stage of putting the hub assembly back onto the spindle. and for the life of me, I can't get it pressed in far enough for the oil seal to be seated properly. I've tried both a new oil seal and the original.

I'm fairly certain i've got the hub assembled correctly. I placed the lip of the rubber seal inside the metal retaining ring and tapped it into place.
What is the trick to get the rubber part of the seal to "pop up over" into position? So far It will only squish and deform.

Thanks!
Shane





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to reinstall hub assembly [200][1990]
posted by  mshonline  on Mon Feb 1 09:42 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.