Volvo RWD S90-V90 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2006 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Engine Rebuild. B6304. Hydralic Lifter/Tappet re-install orientation of oil hole. S90-V90 1998

posted by  Mr. Tool on  Tue Feb 16 03:56 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 1 17:19 CST 2014
[RELATED]

Hi: Have a 1996 S90 (6 cyl). I'm rebuilding the top half of the engine after the guide bearing for the timning belt failed.

I'm re-installing the 24 hydralic lifters/tappets into the head. I did carefully mark them so each lifter when back into the same spot.

P

My question is this. Each lifter has a small oil hole in it's side. Does this oil hole need to be is a special orientation as I install the lifter into the the head?

I don't believe it does, as I think the lifter would generally rotate around as the engine is running.

Do the oil holes all need to face towards the front of the engine?, center? etc?

Any help would be appreciated. Thanks Mr. Tool






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Rebuild. B6304. Hydralic Lifter/Tappet re-install orientation of oil hole. [S90-V90][1998]
posted by  Mr. Tool subscriber  on Tue Feb 16 03:56 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.