Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

E-Fan Wiring Question 200 1988

Got an E=fan from a 940T at the boneyard and replaced my existing GM fan. The 940 fan has three wires, red, black & green. I did not hook up the green wire, only the red (+) and black (-). I believe that the green wire is to run the fan when the AC is on. My AC hasn't worked in over a decade, so I did not hook it up.

The fan runs off of a radio suppression relay and the temp sensor is in the radiator. I ran power from the fusebox and did not splice into any wiring to bring power to the relay. I followed Dave Barton's wiring diagram when I originally installed my GM fan.

The fan will start and run for 15 seconds before cutting off, then come back on in 10 seconds. The cycle continues. And continues....

Something is wrong. Anybody got any ideas? Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New E-Fan Wiring Question [200][1988]
posted by  Stormie  on Sun Feb 28 04:27 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.