Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

high pressure PS hose,clamp,weight on the hose? 200 1988

posted by  joekidd on  Sun Feb 28 07:25 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:54 CST 2014
[RELATED]

Went to replace high pressure hose as the rack end was starting to weep from the crimp. I figured i would get it before it blew out. Ordered aftermarket (Gates i think?) replacement went well but the rack is always groaning now like it is starved for fluid,and yes i have driven it many miles and the fluid level is fine.
Heres the crux,the old 2 piece metal clamp bracket will not tighten down on the upper part of the hose as the diameter seems alot smaller. So i ordered one from from tasca for 136 instead of 85 for the other. Seems to be the same 3/8 inch hose as the Gates hose as the 2 piece clamp/weight balance piece will not tighten down on the new Volvo hose either? Has all the Volvo stickers but says made in the USA. Did not send the required copper washers so the job is on hold anyways.
Anyone had any problems after replacing the Hi-Pressure hose?
What is the purpose of the 2 piece metal clamp/bracket?
thanks in advance
Car is still down as I do not want to ruin the rack!!!!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New high pressure PS hose,clamp,weight on the hose? [200][1988]
posted by  joekidd  on Sun Feb 28 07:25 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.