Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Did I screw it up? 200

posted by  mikeb17 on  Fri Apr 2 17:34 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 12 20:19 CST 2013
[RELATED]

I'm in the middle of replacing my rear brakes on my 92-240. I bought the official Volvo brakes from FCP. The brake pads had a shim glued on to the brake pad, it was a sheet-metal shim coated with a layer of plastic/rubber. I simply put the new pad. But I'm thinking that I need to reuse the plain sheet metal shim from the old brake pads also - the instructions kind-of hint at this. The old ones had two shims on each pad, a plastic coated one and and extra one was plain sheet metal shim. But I don't know why the new breaks didn't have one, the ones I got before seem to have all the parts. Could this be an new design that doesn't need the old piece? Any ideas?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Did I screw it up? [200]
posted by  mikeb17  on Fri Apr 2 17:34 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.