Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bosch Main Fuel Pump wiring question 200 1989

uid 43101's pic
posted by  245DogWaggin on  Thu May 20 06:46 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 12 17:07 CST 2013
[RELATED]

Howdy folks,

Just had a new Bosch main fuel pump delivered from FCP. My dead, old fuel pump was an aftermarket brand and it looks like the PO had spliced on ring terminals to slide over the positive and negative posts which were threaded and had tiny little nuts to hold them down.

The Bosch has smooth, unthreaded posts surrounded by a black and yellow plastic tube. My question is, should I snip off those old ring terminals on my wiring and soldier on new bullet connectors to slide over these posts on the Bosch? Also, should I then just use electrical tape to seal up water from entering the connections?

thanks,
jason






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bosch Main Fuel Pump wiring question [200][1989]
posted by  245DogWaggin  on Thu May 20 06:46 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.