Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Weird - replacement V-belts don't work 200 1992

I drive a 1992 RHD 245 and I have spent the weekend replacing the engine seals, timing belt, etc.

On putting everything back together with new timing, AC and alternator belts, I discover that the new Contitech alternator belts (part no. 10X918) are NOW too short. The 2 bolt intersecting thingawing that the alternator V-belt tightening adjustment bolt screws into is now rubbing against the lip of the fan pulley hub (causing sparks).

Which is weird.......... These new belts are *exactly* the same length as the old Contitech belts (which are the same part no.) and there was no rubbing issue previously as far as I know. I put the old ones back on to make sure I wasn't dreaming and the rubbing is still there.

I am just thinking that the clearance is simply tight and I have left out a spacer between the fan hub and the water pump. But there's no such spacer. I have been careful in keeping track of the bits and pieces. Or am I wrong?

Short of getting longer belts (maybe an inch longer) to get the necessary clearance, I really can't work this one out.

Suggestions anyone?

(FWIW, the local Bosch replacement part no. for 83-93 Volvo is an 11A0925 - i.e., 925mm)

Thanks

Lucast






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Weird - replacement V-belts don't work [200][1992]
posted by  lucast subscriber  on Sat Jul 10 20:03 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.