Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bilstein strut inserts w/ ABS 200 1992

posted by  flood on  Thu Nov 18 23:44 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:07 CST 2014
[RELATED]

Jorrel had said that he could not get the strut inserts to fit into his ABS equipped car on one side, and was going to attempt some modification to try to make it work. I was very interested, because I might be in the same boat. After a little research, found that you are supposed to install a spacer (Volvo OE# 1229423-7) underneath the strut insert housing (above the ball joint) with these inserts, and looking at the picture, I can see how this might allow the insert to drop down a little lower.
Anybody installed these?
Photobucket






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bilstein strut inserts w/ ABS [200][1992]
posted by  flood subscriber  on Thu Nov 18 23:44 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.