Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear Control arm bushings 200 1988

posted by  '88wagon on  Wed Nov 24 09:04 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 22 01:35 CST 2014
[RELATED]

So my rear control arm bushings are beginning to look more like swiss cheese then rubber and I guess it is an appropriate time to replace them. The only problem is that i have been searching the board and the internet alike for tips about removing them and have come up dry.

I am wondering if some sort of special tool is absolutely necessary or if with a bit of work, you gan get em out and then the new ones in. Also, there are 2 bushings per arm is that correct, the one in the front being thinner than the one in the rear?

Any sort of guidance would be most appreciated!

'88wagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear Control arm bushings [200][1988]
posted by  '88wagon  on Wed Nov 24 09:04 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.