Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2004 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M41 assy and parts 120-130

posted by  mcfly on  Mon Feb 28 19:30 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 5 15:40 CST 2011
[RELATED]

I'm rebuilding a M41 tranny with type J OD that was a mess and previously rebuilt by someone that that re-engineered it by leaving out some parts. On the lay shaft for this M41 the spindle and bore for the lay shaft are larger than the M40 (.716 vs .660 on the spindle). The previous builder left out one of the spacer rings that go on either side of the needle bearings in the lay shaft. These on the M41 are larger than the spares I have for a M40. The M41 are .725 ID and .901" OD vs the M40 at .826 OD and .660 ID. The only parts reference I can find is for 87176-4 and it doesn't specify size. Why is this layshaft different in size? Where can I source the proper spacer? I only need one if someone has one leftover they would part with.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M41 assy and parts [120-130]
posted by  mcfly subscriber  on Mon Feb 28 19:30 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.