Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2023 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Transmission mount problem 200 1981

posted by  someone claiming to be weirdwaldo on  Thu Mar 17 21:41 CST 2011 [RELATED]

So I gots me a 1981 245, Recently pulled the engine and tranny for a bearing job. Replaced the motor mounts and the tranny mounts with new ones from IPD.

Now when I try a 'spunky' takeoff from a dead stop I can feel the transmissions raising up and thunking under the center console. I crawled under the car and found just by hand I could lift the tranny up a wee bit. However when I try to tighten the nuts on the tranny mount they're about as tight as I can get them, any more torquing on em and I'll break...something, that im sure of.

Any ideas? Would using some washers as spacers for the nuts work? Anyone else have this problem?

Thanks much





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Transmission mount problem [200][1981]
posted by  someone claiming to be weirdwaldo  on Thu Mar 17 21:41 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.