Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

oxygen sensor test - on vehicle - single wire test point, but then what 200 1988

posted by  tbb2 on  Sun Mar 20 15:04 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 16 18:57 CST 2014
[RELATED]

I am trying to check the operation of my Oxygen Sensor/Lambdsond.

My literature shows a test connector near the battery. The pink (p) wire is to "Lambdsond test point" the other (bl-w) wire is a "Idle Connector".

If using the Idle Connector the book says be careful not to miss and get the Lambdsond test point because the grounding test for the Idle Connector will damage the Oxygen Sensor.

I have a test point and a book with the specifications (cold=3 ohms, warm=13 ohms).
I have a digital multi-meter.
I don't have a lot of experience with electronics.

So what do connect to what to check the resistance of the oxygen sensor at the 1 (one) wire?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New oxygen sensor test - on vehicle - single wire test point, but then what [200][1988]
posted by  tbb2 subscriber  on Sun Mar 20 15:04 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.