Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/1999 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Installing a tow bar, is it o.k. to drill through spot welded nut? 200 1986

Here is a photo of a hole near the storage area of my 1986 240 Wagon.

Is it o.k. to drill through the spot welded nut which at the bottom of the hole? Doing so would make the installation of the tow bar much easier. The installation instructions which came with the tow bar say that the nut should be removed.

Before I do this, I'd like to know if I might regret doing so in the future.

Is there any use for the spot welded nut?







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing a tow bar, is it o.k. to drill through spot welded nut? [200][1986]
posted by  mkoch subscriber  on Tue Mar 29 23:24 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.