Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

UUUGGHHH changed intake gasket wont idle!!!!!!!! 200

posted by  DEVO! on  Sat Apr 23 18:53 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 19 15:17 CST 2012
[RELATED]

Ok today I changed my intake gasket FI orings and breather box.
Went to start her up after I finished and she idled fine a little lopey but better than before. Drove her around the block and parked her, I went back to start her up because I needed to go to the store she started up and slowly died! Idle was normal for a few seconds then she just started idling really low and died out. 5 starts after and she still keeps doing it. I checked all my vac lines and even replace a few while I had her all apart. When I replaced my breather box I noticed it did not fit very tight at the bottom oil line, the breather box I replaced my old one with was also not a tight fit either. I am pretty sure the intake it on pretty tight and I rechecked everything. I really hope someone can help I am really stumped I'm just sitting here in the garage trying to figure it out. HELP!
--
Dean 1991 240 wagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New UUUGGHHH changed intake gasket wont idle!!!!!!!! [200]
posted by  DEVO! subscriber  on Sat Apr 23 18:53 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.