Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

rear flange on driveline 120-130

posted by  greezy on  Sat Apr 23 20:47 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 4 21:21 CST 2011
[RELATED]

There is a round flange on the rear end and it mates up to a round flange on the back end of the propeller shaft. Only mine doesn't fit perfectly. With the bolts out, it wobbles very slightly. Not sure why, I just remember this detail from a year ago when I replaced the driveline. So, now the seal leaks from the front of the pumpkin. I will take the driveline off and replace the seal. But I wonder if there is a method for centering these round flanges on each other, and making them mate up. Seems like anything I do at home with a file is likely to make them off-center from each other. Do I need a machine shop?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear flange on driveline [120-130]
posted by  greezy subscriber  on Sat Apr 23 20:47 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.