Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

The bracket for the crank positioning sensor cracked. Transmission removal againain? 200 1991

posted by  vacuumhead on  Tue May 10 19:37 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 12 06:49 CST 2014
[RELATED]

One of the last steps in my replacement of the transmission was to install the crank positioning sensor. I couldn't get the bolt to tighten. A closer look revealed the back
Looks like The only alternative for replacing this bracket is to again remove the transmission and basically start at square one again. There MUST be another alternative.
Am I up the Volvo creek here again?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New The bracket for the crank positioning sensor cracked. Transmission removal againain? [200][1991]
posted by  vacuumhead  on Tue May 10 19:37 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.