Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front door panel moldy and falling apart 200 1986

posted by  Xraybob on  Sun Nov 27 17:16 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

Pulled my DS front door panel to lube the window regulator and found the bottom
third of the inside to be damp/moldy/crumbling due to exposure to moisture over the years. What can be done with the remaining material to seal and protect it from future issues? I'm going to pull the PS next week and seal it if there are any problems with that one. I installed fresh window scrapers a few years ago and the plastic barrier shield is still in place. Any suggestions are welcome. Thanks.
--
'86 sedan with 467,000 miles on the original engine and automatic transmission






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front door panel moldy and falling apart [200][1986]
posted by  Xraybob  on Sun Nov 27 17:16 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.