Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Getting EZK Ignition Fault Code 2-4-1 900 1994

posted by  dpujara on  Wed Dec 14 21:55 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 12 17:25 CST 2013
[RELATED]

1994 940 Non-turbo

I've had the Check Engine Light for a few months. When I checked for the OBD Diagnostic Fault Codes, I got the code 2-4-1 from socket 6. As per the codes specified in Table 2 of the FAQ, the code means the following:

2-4-1* Fault condition: EGR system flow too low
Causes: Faulty wiring, EGR, EGR vacuum or controller; EGR temp sensor
Symptoms: Poor idling

The car's idling seems to be fine when I'm at a Stop light or when I start the car.

Please give me ideas as to how I can pin point the cause of the Check Engine light and how this can be fixed.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Getting EZK Ignition Fault Code 2-4-1 [900][1994]
posted by  dpujara  on Wed Dec 14 21:55 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.