Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

My experience with an ECU Reset switch for using LPG & Petrol 700

posted by  rbb_in_oz on  Thu Feb 2 21:44 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 25 01:30 CST 2014
[RELATED]

Hi,

This image shows the ECU reset box that I've installed on top of my steering column. It contains a "push to break" momentary off switch to reset Port 14 on the LH-Jetronic ECU. It also contains two LEDs which show the status of the cruise control system. I've included a resistor, activated by the small SP switch, which dims them for night driving.

The ECU reset is needed as the engine requires a "fresh start" when switching from LPG to Petrol. Also, when idling for a long time using LPG, the Lambda Sensor light comes on. This is due to the preset values for the sensor not matching the exhaust from the engine when running on LPG. Pressing the reset switch for 5 seconds resets this light.

I've included a 10k resistor in the circuit between the ECU reset switch and port 14 so that , when open , the voltage goes to ground. By the way, the current is only 2.3 mA.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New My experience with an ECU Reset switch for using LPG & Petrol [700]
posted by  rbb_in_oz  on Thu Feb 2 21:44 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.