Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

no power to FI Relay terminal 30/ 25amp fuse ok 200

posted by  transit wind on  Tue May 1 20:52 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 22:40 CST 2014
[RELATED]

I've got a no start problem. The power coming from the 25amp fuse is showing good but its not reaching the relay with key off. During crank there is no power at the two other terminals (86/87? can't remember but according to Bentley test). I do have power to the ECU.

I have recently had issues with the 25 amp fuse holder which was replaced. Then soon after the FI relay went bad and with a change of relay everything was fine for a short time. Now no power to relay. I've been searching the archive but haven't found anything helpful.

I checked the fuse panel and swapped out the FI fuses with good ones. Also rotated fuses a bit to get a better contact. Might need to try more cleaning.

So the 30 red wire goes from the 25amp fuse to the relay? Could the ignition switch keep the power from reaching the relay?

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New no power to FI Relay terminal 30/ 25amp fuse ok [200]
posted by  transit wind subscriber  on Tue May 1 20:52 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.