Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ignition problem help please 200 1991

posted by  240_tool on  Sat Jun 9 10:00 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 18 11:17 CST 2012
[RELATED]

im new to the forum need some help with ignition

my room mate has a 91 240 with a Crank position sensor

replaced auto trans the other day and the rear main seal.
i forgot to mark the flexplate. so i positioned the car to TDC and then placed the flex plate back with the arrow pointing towards tdc(was a couple degrees off) put everything back. loaded the fluid and now the car idles a little rough and i can only get a little acceleration. i drove the car before tranny was replaced so i had to have done something during the swap. ive never had a car with a crank position sensor, could the couple degrees cause the timing to be off and not getting sufficient ignition?
i did remove the first plug to confirm TDC and replaced it. but i tested that already. please help thanks!


on the side note
fuel pump has acted up once or twice(or so it seemed like it)
when i disconnect the maf nothing happens could that be the problem?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ignition problem help please [200][1991]
posted by  240_tool  on Sat Jun 9 10:00 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.