Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Loose disc in front drive shaft--need solution 200 1988

posted by  Bill N. on  Tue Jul 17 12:30 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 16 14:09 CST 2014
[RELATED]

I put a new driveshaft support bearing on my 88 240 and in the process of removing the old one, I broke off a small dics that was welded inside the shaft. I was using it to push off on when I pulled the old bearing off hte shaft.

Now it is tickling around inside the shaft and I can not get at it with anything to cut it or remove it.

All I want to do is keep it quiet and stop it from making noise everythime I drive the car. I thought about some spray foam to hold it still. Before that, I would locate the disc at the far end laying flat.

Any other suggestions?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Loose disc in front drive shaft--need solution [200][1988]
posted by  Bill N. subscriber  on Tue Jul 17 12:30 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.