Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oil leak after reconnecting flame trap 200

posted by  42 on  Thu Jul 26 01:00 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 22:13 CST 2014
[RELATED]

My new to me 1990 240 has started leaking oil near the rear of the engine. It's hard to figure out the source, but when I bought the car the flame trap had been disabled and plugged up with a screw and a bolt. I bought and installed a new flame trap, and at about this time the oil leak started. Is it possible that the system was disabled because it was leaking oil? I assume that it would be coming from the plastic oil separator box coming out of the block. I'm considering replacing the box, but I don't know if it's a very unlikely cause. Any help would be much appreciated.
David






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil leak after reconnecting flame trap [200]
posted by  42  on Thu Jul 26 01:00 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.