Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2009 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Help about unlocking the flange to center shaft support 120-130

posted by  DBS on  Wed Aug 8 11:35 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 19:33 CST 2014
[RELATED]

Hello and help!

I got the propel shaft (from tranny to center) down. I already got a new rubber donut and bearing to replace the worn out center support.

But...how in heaven am I able to unscrew the large bolt to remove the flanges and bearing from the shaft?! I tried everything (hammering, leverage, etc) but that nut just refused to budge.

To make sure, is the nut supposed to loosen counterclockwise? I was wondering if it was opposite and that I was just tightening it instead of loosening!!

Any help/tips greatly appreciated! Many thanks!

-DS

(I had tried roaming through Brickboard for tips with no luck)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED Help about unlocking the flange to center shaft support [120-130]
posted by  DBS  on Wed Aug 8 11:35 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.