Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveline vibration? 700

745 A/T. New center support bearing, U-joints, trans bushing & seal. I shimmed the middle up 1/4" and down 1/4" The two drive shafts are splined in a way that makes it impossible to put together "wrong".
Still vibrates at 25mph and mellows out as speeed increases. I noticed in neutral there is no change in vibration. So the question is...Is the driveshaft still spinning at the same rate in neutral as it is in gear? I switched wheels and tires with zero change. TIA






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveline vibration? [700]
posted by  seven40T  on Thu Dec 13 22:28 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.