Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Why am I going through so many endlinks? 200 1986

posted by  Xraybob on  Mon Dec 17 10:16 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

Over the past 2 years, I broken the driver's side endlink shaft. The original on lasted from 1986 until 2010. I replaced it with an OEM one from a boneyard car until that one broke. Now today I'm getting ready to install my 4th one. They seem to snap a different locations on the shaft, but it's only on the driver's side. Note: I am using poly bushings, but I started using them about 5 years before the original link broke. I drive my car very gently and don't hit any potholes and drive 75% highway. Any thoughts or suggestions?

Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Why am I going through so many endlinks? [200][1986]
posted by  Xraybob  on Mon Dec 17 10:16 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.