Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Bench-testing overdrive relay 200 1984

Short version - How do you bench-test an overdrive relay?

Long version - My OD for my M46 tranny stopped working. I bypassed the relay using the method described here ( http://www.brickboard.com/PRINT/?id=796055 ) and it engages just fine. I put an ohmmeter across the shift-knob switch and it works fine. I have installed several OD relays, a few of which I was told were functional, and still nothing. I've tried resoldering a few of them as well and still nothing.

I assume that either my relay karma is bad or maybe the 4th-gear switch is bad. It would be easier to confirm that a relay is good before digging for that 4th gear switch (which I don't want to do in the cold and snow), so can someone help? I do have access to a 12-volt power supply if that's needed for testing.

As long as I'm on the topic, do I have to lower the tranny to access that switch?

Thanks.
--
Mike F - 1984 244 DL - 317,000 miles
Original engine, transmission, drive train, starter
Undergoing reconstructive surgery with POR-15

1972 142 S - The Yellow Brick - 135,000 miles
All stock except for Weber Carb. B20B engine. M40






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bench-testing overdrive relay [200][1984]
posted by  Lord Volvo subscriber  on Sun Jan 13 13:02 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.