Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

regrading an 1989 240 m47 transmission 200

posted by  trichard on  Tue Apr 9 05:27 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:52 CST 2014
[RELATED]

with this transmission on a bench does anyone know how the input shaft is supposed to act when the shifter is placed into each of the 5 gears, neutral and reverse?

by this i mean, "should" the input shaft rotate with the normal resistance based upon each gear ratio and in turn cause the output shaft to rotate as well?

clearly in neutral there is no resistance so it should spin freely?

or does the input shaft turn slightly and stop when each gear is engaged?

obviously i have next to no experience with these transmissions.

logically it would seem the input shaft would turn at different levels of resistance as 1-5 is used which would cause the output shaft to rotate. but this is supposition on my part not borne of experience.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New regrading an 1989 240 m47 transmission [200]
posted by  trichard  on Tue Apr 9 05:27 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.