Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Resetting yellow "SERVICE 200 1989

I know, I know, this has been asked many times before--and believe me I searched the archives--but for the record...do you PULL DOWN on the black lever or PUSH UP to reset the SERVICE light?

I've reset it before without any problems, but I don't do it often enough that I can just go through the motions without thinking. I never can remember if you pull the lever down or push it up, or if it alternates with each resetting. I pushed the lever up and felt it give way and thought I had reset the light. The SERVICE light still stays on for a minute or two before turning off. Thought I had reset it.

I looked up the archives and there is a post with this question for an '89 and the response was to PULL on the lever. "Pull" suggests that the lever pulls down. So yesterday I tackled it again, but there seems to be no room for the lever to go down. I didn't want to break it so I gently applied force downward but I don't think it can pull down. So I pushed it up again. I haven't started the car since, as it's parked.

So what is it? Pull down or push up on the black lever?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Resetting yellow &quot;SERVICE [200][1989]
posted by  someone claiming to be ugly duckling  on Fri Jun 14 14:02 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.