Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Help in removing the MCC unit from dash? 900 1994

posted by  rstarkie on  Wed Jun 19 11:33 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

1994 944t 231K

The AC compressor is not getting 12v from the MCC unit in the dash. I have encountered this in a 1991 745t and it was a bad solder relay joint on the control board. It just required resoldering and everything was cool again.

After pulling off the faceplate I removed the four corner screws on the unit but the lower corners can't move out because of the metal tabs that are circled in the image below.

Does the radio have to come out to get at additional fastners that secure the metal tabs? There is a Kenwood unit in the car and I do not have the "tools" the original owner would have received that would unlock the unit.

Thanks, Randy

photo 773_zps8ea02ecd.jpg






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help in removing the MCC unit from dash? [900][1994]
posted by  rstarkie subscriber  on Wed Jun 19 11:33 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.