Hello all,
I recently did a "fix" on sticky odometer gears ( actually I ended up, after replacing the gears to no avail, drilling a strategically placed hole in the cluster plexi-glass just big enough for a bike spoke to fit through and nudge the gears forward past the sticking point - ok I'm a bit of a hack) when I got everything back together I had no low beams - only high. I replaced the step relay out of a lack of any clue how to test the circuit. $50 later and now I have no high beams with the new step relay. I suppose I could pull over and swap the relays every time I want to toggle the beams but it sounds like a pain. I'm hoping one of you whizzes will know just what this points to.. Is there anything in the back of the cluster that I could have broken that would cause this?

thanks in advance