Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2007 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Intermediate shaft seal went on too far...? 900 1995

posted by  RepairmanJackal on  Sat Oct 26 11:58 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 10 09:52 CST 2014
[RELATED]

1995 B230FD 270k.

Was suffering from seal problems at the cam and intermediate shaft. I had a new head, belt, and OEM pump on hand, so I'm doing it all at the same time.

When I got the covers off, I found that the intermediate seal had actually popped out - probably the source of the major oil loss.

I put on the new seal and while pressing it, the dang thing went in too far. It's even and it's fully seated, but I don't think it's supposed to be this far down... Concerned that it's going to leak again quickly if this is improper.

Am I worrying about nothing? Can the intermediate seal be in too far? I don;t see an oil drain-back hole, there are no problems with curling, and I can't slip it back out with a thin pick.

Do I leave it as-is, or do I pull the cover and risk damaging my pan gasket?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intermediate shaft seal went on too far...? [900][1995]
posted by  RepairmanJackal subscriber  on Sat Oct 26 11:58 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.