Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

940 gas tank seal reuse issue 900

posted by  lrisius on  Fri Nov 1 08:56 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 17 05:59 CST 2014
[RELATED]

Hi,
Thought I would post this out as an FYI in case someone else may run into the same problem and can order the part in advance.

About 4 months ago, I replaced a fuel pump in my 92 940. I bought a new seal and ring from Volvo. Recently, I had to replace the gas tank sending unit due to a problem that developed with it. I figured I could just reuse the four month old seal and ring. When I went to re-install, the seal had swollen (or stretched) noticeably and was no longer tight around the sending unit- its diameter was too large. I fiddled with it quite a bit but couldn't get it back into the tank. Fortunately, I had saved old (probably original from factory) seal and used it. It was nice and snug and went in well.

Not sure what the issue was. Maybe a different rubber is being used? I did apply some petroleum jelly to ease installation, maybe that caused it? I assume these things would hold up ok once installed as long as you don't need to re-open.

Lyle






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 940 gas tank seal reuse issue [900]
posted by  lrisius  on Fri Nov 1 08:56 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.