1992 745 Regina 200K

I got a couple of years of service out of a used b234f exhaust system on this b230f car but the free ride has come to an end.

The header pipe has a lot of pin holes in the area where the heat shield covered the converging pipes. I was going to try to have those welded, but the connections of the component pipes are so bad I think the system would just imploded if I tied to take them apart.

So I need a complete exhaust system for a Regina system from the exhaust manifold back. FCP shows a head pipe but it is listed as an EGR pipe. They are not showing a cat for this car either.

So has anyone replaced a header pipe and cat on a Regina car lately? Where did you get the pipe and cat and what was the quality of the fit between the pipe and the manifold.

Thanks for any help.

Randy