Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Clutch Slave Cylinder 120-130 1968

posted by  greendread on  Mon Apr 14 06:09 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 2 08:56 CST 2014
[RELATED]

Hello All,

After a brutal winter I am getting the 120 back out on the road. I fould the clutch slave cylinder diaphragm had failed. I know this time it was due to the car sitting since October, but this is the 3rd time I've had to replace it. I chose not to buy from ipd, and went with my local lod school parts shop.

The only thing is- it doesn't come with a boot, or a diaphragm. Buy diaphragm I mean rubber seal on the back of the slave cylinder before the boot. Is this normal? I used an old boot I had in the trunk, installed the thing, and now I can't get pressure. There seems to be a leak at the front of the slave cylinder where the hose meets the front if the cylinder, and above at the junction for the hose. Hoses were replaced last fall. Everything is as tight as can be.

I've never had a problem on install, I am wondering if my clutch slave cylinder is defective.

Thanks in advance!
greendread





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Clutch Slave Cylinder [120-130][1968]
posted by  greendread  on Mon Apr 14 06:09 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.