Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

A couple questions pertaining to head gasket procedure 200 1990

posted by  1990Volvo240 on  Thu Jun 26 13:17 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 3 13:18 CST 2014
[RELATED]

Hi,

I'm hours away from starting headgasket job. It will be my first but I have dealt with replacing intake man. gaskets, exhaust man. gaskets and the other tidbits before so it shouldn't be too bad...yeah, ahem...shouldn't.

Anyway, I will be taking it to the machine shop upon removal. One of my questions was do most of you remove all of the sensors from the head before taking it to the machine shop-temp gauge sender, temp sensor, etc.? If so I am guessing I will need to anneal the temp sensor's washer before installation?

One last think that had me puzzled, when I called the machine shop and explained what I would need done he asked "Is it very dirty?" I replied "No, not too bad." What did he mean by that?

Thanks,

Travis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New A couple questions pertaining to head gasket procedure [200][1990]
posted by  1990Volvo240 subscriber  on Thu Jun 26 13:17 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.